Dear Insulation4Less,
My name is David. I am the Warehouse Manager for Schlossadler Wines, Inc. We are an international boutique wine distributor with a 9,300 sq. ft. warehouse in Oceanside, CA. Approximately one month ago the owner of the company (my boss) came to me with the task of researching, ordering, and installing insulation for the ceiling of the entire building by myself. With limited experience in this particular area under my belt, I accepted the project anyway. I honestly didn't even know where to start. I sent detailed photos along with our information and questions to your sales team. They replied promptly with very easy instructions and recommendations as to "what type" and "how much" product should be ordered to complete our mission. Now, one month and about 200 hours later, my boss is extremely happy, our stock is cool, and I've received a very generous bonus!!
Thanks Insulation4Less, I will definitely spread around the words: "foil-foam-foil!"

Sincerely,
David W.
Warehouse Manager
Schlossadler Wines, Inc.
Oceanside, CA

This is Gary…
I had used the double sided foil to insulate my barn.
Upper and lower floors.
It has a concrete lower floor 36' x 36'. The upper loft is 15' x 36' with 9 foot ceilings.
When it is a cold 27 out, it's a constant 43 to 45 in the lower level.
I purchased the 4' rolls by 100ft. or so. My studs were 24" apart so I cut the rolls in half.
I like the clean simplicity of the installation. I used 1/2" x 1/2" staples.

Gary Lewo
Squaw Valley, CA

1st time I used Prodex. The 1300 sq.feet attic was 36" High at the highest point. The framers were off by up to 1"spacing the rafters. 48" width didn't make it some places.
The attic became cooler as I progressed with job. Big difference, I loved it.
The leftovers I'll use for my cars and for camping. I am recommending Prodex to everybody I know. Easy to cut, to shape, to install. No itching fiber. That attic would be hard to insulate with standard 6"glass fiber.
I am glad I found you.

Thanks,
ILJA MARAN,
Santa Monica, Ca

We recently used your product Prodex to insulate our warehouse in southern California. We occupy a 3,500 square foot block building with a flat roof. For the past two years the summer heat literally made it impossible to work in the space.
This spring we stapled Prodex to the rafters, creating a 12" dead air space and installed just two rotating vents to get warm air off the ceiling.
We now enjoy a space that visitors think is air conditioned. On hot days the temperature differential from outside to inside has exceeded 15º.
In every way, your product exceeded our expectations.

Thanks!!!!
Robert Rasner, CA

We are using two layers of your insulation. There is only one panel in the photo that has the second layer finished. It is the one on the right. We wanted the structure of the dome to show for effect and we wanted the double layers for the insulation value. The second layer is carefully cut and finished. It was taped before it was put up. It acts as the ceiling. It isn't painted or covered.

With just one layer up I've already noticed a very significant decrease in heat in the summer and warmth in the winter.

Margaret Denial,
Cotati, CA